FAKE CAR ALARM LED LIGHT ~ 3mm ~ CHROME RED & BLUE ALTERNATING 12v 24v

Description: AUTO THEFT DETERRENT LIGHT ( FAKE CAR ALARM ) This listing is for two LED car alarms as pictured (second LED car alarm is FREE!) Brand New! Ultra Bright device, designed for 12 and 24 volt applications, flashes on and off in less than a second (around 100 times per minute). This vehicle theft deterrent light product can protect your property from potential thieves, especially at night. The bright flashing LED light simulates the lights used in expensive vehicle alarm systems, causes thieves to pass your vehicle in search of an easier target. The light can also discourage break-ins in daytime. Easy to install and looks clean on your dash panel. The LED light will flash when your ignition is turned off and will not flash when you have your ignition switch on. This LED alarm does Not require a car alarm system and has extra long wire for easy connection. MADE IN USA. Details: * 2 pcs 3mm Red & Blue alternating LED fake car alarm device * 24 inches of quality UL listed power wire. Should be long enough for most installations * Input voltage: 10~28 Vdc. * Chrome plated metal housing, washer and nut included * Can be mounted to metal or plastic * Looks good on dash panels or other areas like fiberglass * Small compact size * 12 year + LED life span * Car, Boat, Motorcycle, RV, ATV, DIY * low power consumption. less than 20mA when blinking * Yery bright ! Luminous intensity: 5,000 mcd * Simple install instructions included * Made in USA We can also supply 6 volt fake car alarm lights. Just ask! Do you want other colors or custom types?....See our store, or e-mail inquiries! LED mounting information: * Panel cutout hole (hole diameter in you panel) = 1/4" (0.250 inch) * Panel thickness: 0.030" ~ 0.200" * Outer most diameter of body: 9/32" (0.281 inch) Colors available: Yellow, Red, White, Blue, Green, Red/blue alternating, RGB, Others. (see listings) *We can also supply non-flashing assemblies Simple Installation: 1, Locate a good place to mount your flashing LED, make sure you have access to the back to run wires. 2, Drill a 1/4 (0.250) inch hole for the LED chrome bezel. 3, Insert LED assembly into hole. 4, Install washer and nut, tighten. Simple two wire connection: 1, Connect RED wire to fuse block that has 12 volts when vehicle is running or not (Hot at all times) 3, Connect YELLOW wire to fuse block that has 12 volts only when vehicle is running (Hot when running only) Other Applications: * Can be used for both 12 and 24 volt applications * Want to connect these or other LEDs to your low voltage A/C transformer? Just use the LED rectifier we also have listed(see listing)! Made in USA

Price: 5.99 USD

Location: Holly, Michigan

End Time: 2024-08-29T19:42:55.000Z

Shipping Cost: N/A USD