T2-PMC Quad ADSP-TS201S TigerSHARC PCI Mezzanine Card

Description: T2-PMC: High-End Multiprocessing, Scalability, and Unprecedented I/O BandwidthBittWare’s T2-PMC (T2PM) DSP board features the ADSP-TS201 TigerSHARC processor from Analog Devices. To take full advantage of this highperformanceDSP, this multiprocessor PCI Mezzanine Card (PMC) implements BittWare’s ATLANTiS, which combines robust TigerSHARC processingwith the versatile Virtex-II Pro FPGA from Xilinx to offer ultra high performance and unprecedented I/O bandwidth.The T2PM matches a cluster of four ADSP-TS201 TigerSHARCs with:● High-bandwidth, low-latency off-board I/O, reconfigurable fornearly any application● High-speed interprocessor communication network to facilitatescalability● SharcFIN PCI-DSP bridge for integrating DSPs with PCI bus andother peripherals● Comprehensive software for ease-of-useThe board also provides a large on-board bank of SDRAM and flashmemory for hostless boot.High-Performance TigerSHARC ProcessingThe T2PM features a cluster of four ADSP-TS201 TigerSHARC DSPs,which are interconnected by a 64-bit, 83.3 MHz cluster bus. TheADSP-TS201 processor operates at up to 600 MHz, providing3.6 GFLOPS of peak processing power. Because of its superscalararchitecture, the ADSP-TS201 is also efficient at fixed-pointprocessing, with each DSP supporting 14.4 BOPS of processing.Along with 24 Mbits of on-chip RAM, each DSP also boasts fourhigh-speed LVDS link ports. Each full-duplex link port is comprisedof a 4-bit transmit and a 4-bit receive channel, and can support upto 500 MBytes/s in each direction for a total maximum throughputof 1 GByte/s. Two link ports from each DSP are used to createan interprocessor communications ring, and the remaining twolink ports are routed to the ATLANTiS FPGA. When connected toATLANTiS, the link ports run at 250 MBytes/s (125 MBytes/s perchannel).SharcFIN PCI-DSP BridgeThe T2PM features a BittWare SharcFIN PCI-DSP bridge chip that givesthe DSPs low-overhead access to the host via the 64-bit, 66 MHz PCIinterface. The SharcFIN also provides a general purpose peripheralbus that allows the DSPs to access the Flash and the FPGA controlregisters. It also provides host access to the DSPs, on-board SDRAM,Flash, and FPGA control registers. Features• One cluster of four ADSP-TS201 DSPs @ up to 600 MHz♦ 14.4 GFLOPS per board (3.6 GFLOPS of floating-point power perDSP)♦ 57.5 BOPS per board (14.4 BOPS of 16-bit processing per DSP)♦ 24 Mbits of on-chip RAM per DSP♦ 8 link ports @ up to 1 GByte/s each♦ Static superscalar architecture• Xilinx Virtex-II Pro FPGA (XC2VP30) featuring 3 million gates• ATLANTiS FPGA featuring 4 GBytes/sec of external I/O throughput viaVirtex-II Pro routing♦ 8 link ports @ up to 250 MBytes/sec each♦ 64 high-performance DIO (single-ended and/or LVDS)♦ 8 channels RocketIO™ high-speed serial transceivers• PMC form factor with BittWare’s PMC+ I/O extensions (64 DIO to FPGA)• Up to 256 MBytes of on-board SDRAM• 64-bit, 66 MHz PCI interface via BittWare’s SharcFIN PCI-DSP bridge• 8 MBytes of Flash memory• Two link ports per DSP dedicated for interprocessor communications• Complete software support, including remote control and debug,support for multiple run-time and host operating systems, and optimizedfunction libraries with carrier board and high-speed cable set.

Price: 3999 USD

Location: Budapest, BP

End Time: 2024-01-16T14:54:58.000Z

Shipping Cost: 100 USD